Kenton high quality ready made leads

IEEE DCB to DCB leads


Kenton 14 pin IEEE DCB to DCB cable one direction 2m (Roland) (See Note 1)

Inc. Vat: £44.10

Exc. Vat: £36.75



Kenton 14 pin IEEE DCB to DCB cable bi directional 2m (Roland)
(See Note 2)

Inc. Vat: £56.70

Exc. Vat: £47.25


Note 1
14 pin IEEE DCB to 14 pin DCB cable one direction only -2 metres
Used for connecting two pieces of DCB equipment to each other. This cable is fine if the signal direction is always in the same direction - for example, where the sequencer always plays the synth.
For example, this cable allows an MD-8 to control a Juno-60.
This cable allows the signal to go from DCB device A to DCB device B. If you want the signal to go from device B to device A then you will need to unplug the cable and plug it in the other way round.
This lead is NOT for connecting to a Pro-DCB, Pro-2000 or Pro-4. See the "Kenton Connect Leads" section for that

Note 2
14 pin IEEE DCB to 14 pin DCB cable both directions -2 metres
Used for connecting two pieces of DCB equipment to each other - this cable is more convenient if you want the ability to change control signal direction without the need to swap the cable round.
For example - this allows an MD-8 to control a Juno-60 AND the Juno-60 to control an MD-8, with no need to swap the ends of the cable round.
This cable allows the signal to go from DCB device A to DCB device B and also from device B to device A. You don't need to swap cable ends when you want to send the signal the other way.
This lead is NOT for connecting to a Pro-DCB, Pro-2000 or Pro-4. See the"Kenton Connect Leads"  section for that.